INSTALLATION COMMISSIONING ENGINEER JOB DESCRIPTION
Here are some duties and responsibilities of an Installation and commissioning job that we put on our resumes if we apply for a job.
It is stated below what it is and what is done as an installation commissioning. Let's check and put in our curriculum vitae.
1. Read and understand general plans, isometric drawing,
orthographic drawing, P&ID and engineering drawings.
2.
Conduct a JHA before commencing each job, leading to
the elimination of hazards in the work area.
3. Alignment checking between Drivers to the Compressor
4.
Suction Filter take off from the Compressor
5. Each related Piping Removals around the
compressor.
6.
Compressor removal from the based skid and transporting
to the facility
7. Suction Filter transporting to the facility for
cleaning and each related Piping
8.
Disassembly the compressor at the facility
9.
Clean up the casing including that the entire
parts
10.
Bearing inspection (Clearance Measurement and NDT)
11. Assembly of the compressor
12.
Preparation of the Pneumatic Test for the compressor to
itself
13.
Conducting of the Pneumatic Test of the compressor to
itself
14.
Transport the compressor to Site from Facility and
install back on to skid
15.
Execute to Pre-Alignment between the compressor and
driver
16. Clean up the suction
filter and restoration it.
17. Related
piping’s restoration on the compressor unit including cleaning
18. Final
Alignment check between Driver and the compressor
19. Replace
Lube. Oil Filters Elements
20. Leakage
Test of the process Gas Line with Nitrogen at Designed Pressure
21. Preparation
for startup of the Compressor
22. Mechanical
Running Test
23. Final
meeting in the client for the performance of the overhauling wet or dry
type Compressor